The steps required for the assembly of the Plus kit include screwing in the fasters, wiring the electronics, and going through calibration.
For more information, click here to view the full guide. See early assembly videos at printrbot.com/plus.
The steps required for the assembly of the Plus kit include screwing in the fasters, wiring the electronics, and going through calibration.
For more information, click here to view the full guide. See early assembly videos at printrbot.com/plus.
The link goes to a dead page and the PDF is gone
I need to re-flash the printer board and check the heated bed connection on an assembled Metal Plus. So I need to know how it was put together, so I can properly take it apart. Where can I find this information? As Julia stated above, the link goes nowhere and the PDF isn't where Sam of the support team says it is. Please help. Thanks.
The following link reaches a pdf with the assemble instructions for a 1412
https://drive.google.com/file/d/0B9oj0J-4qhdjdHIzTHQySjJEQkE/view?pref=2&pli=1
One correction on the parts list. The idler gear bearing that is opposite the extruder gear is not a 625 bearing, but a 624 bearing. So if you need to replace this idler bearing, choose the 624 bearing. Below is a link to an all metal 624 bearing that looks the same as the one in the Printrbot Plus 1504. https://www.amazon.com/dp/B01CUTIT1A/_encoding=UTF8?coliid=I3KUHGXHL540PG&colid=C6TBKMHENFVP&psc=0
If you are looking for the idler gear bearing above it will be listed as 624ZZ which I guess means that it is all metal.
5 Comments