Using Cura to Calibrate Your Auto-Leveling Probe


If you built a Simple kit, recently swapped hot end tips, or hot ends, you will need to calibrate your Auto-Leveling Probe.  Watch the videos below on probe calibration for details.  Although we are using a Simple for the example, the workflow is the same for any Printrbot model.



...In the video, Tom references Printrbot's recommendation for Repetier.  Since the creation of this video, we have begun using Cura as well.  Thanks Tom!


For more information, click here for the full guide or download the "Using Cura to Set Up Your Auto-Leveling Probe and Create Your First Print" PDF directly below the article.

Have more questions? Submit a request


Please sign in to leave a comment.
Powered by Zendesk