For a full guide on best practices with your Ubis 13, download the pdf at the bottom of this article.
Aside from setting your retraction (0.3-0.5mm) and keeping the fan running, there are a few other things that you can do to optimize the performance of your Ubis 13 Hot End.
- Download the Ubis 13 Cura Profile for Printrbot approved settings.
- Make sure that your fan shroud is placed just above the heat block on the heat sink. Click here to download a printable file for the updated fan shroud.
- Set the proper tension of your extruder spring.
- Keep your filament dry by storing it in a container with desiccant.
- For a full guide on best practices with your Ubis 13, download the pdf at the bottom of this article.
6 Comments