Ubis 13 Cura Profile

The preferred profile to start using your Ubis 13 with your Printrbot.

Key changes: Retraction Speed; 45mm, Retraction Distance; 0.7mm

 

 

Have more questions? Submit a request

4 Comments

  • 0
    Avatar
    shawn kirsch

    I will try this out. Brook seemed to thing it was .3 -.5 in a youtube video....

  • 0
    Avatar
    Pmlammers

    Hello,

     

    I just received my Ubis 13S today... There doesn't seem to be much info about it in the forum yet. 

    The page below states that no cooling fan is required, but the manual (downloaded from the same page) states that air should be blown on the fin structure.  My question is, have I misread something here? Should I use the fan with the updated fan shroud as recommended for the Ubis 13? Is there an updated best practices pdf for the Ubis 13S?

    http://printrbot.com/shop/ubis-13-s-hot-end/ 

    -Pete

  • 0
    Avatar
    Rayco30

    The latest version doesn't require fan, I just got mine and questioned the same thing.  They just need to update the pages....mine runs like a champ with no upper extruder jams whatsoever- heatup times are quick!  prints great

     

  • 0
    Avatar
    Pmlammers

    I didn't realize that printrbot had not posted here. I received an email, or else a response on another thread confirming this. I printed a nose cone for a toy rocket I am making with my dad for my nephew. The test print of just the top half inch printed just fine without a fan. Very clean, no sag, angle of the incline was good. However, printing the whole thing (575 layers, 130mm tall) the same section printed very messily. I concluded that the Ubis 13s works great without a fan on short jobs, but would recommend a fan on the cold section for long prints.

Please sign in to leave a comment.
Powered by Zendesk