Have more questions? Submit a request

3 Comments

  • 0
    Avatar
    Eric Rush

    What do you have to do to have the top fan on the play the whole time while the nozzle fan can have flexible timing?

  • 0
    Avatar
    Eric Prothero

    I just got the Printrbot Play with Cura 15.04.6.  Worked at first when printing the test object, but it didn't hold together well, and didn't stick to the bed.  So I tried adjusting the Z-axis (know I don't know much about all this yet) then it stopped extruding anything.  I pushed down filament into extruder body as far as it would go, with shroud off.  Now drive gear making a clicking sound as filament not being pushed in - nothing being extruded.  Temp at 210 C.  Please help as my 12 year old son is new to this and discovering either it's cool or not.

  • 0
    Avatar
    PB Support Team

    Hi Eric, it sounds like perhaps the Z offset was set too low and now there may be a clog in the hot end.  Try the tips in this section to free up the jam: Extrusion - Clogging, Clicking, Jamming...

     

    I hope that is helpful,
    Dave -pb

Please sign in to leave a comment.
Powered by Zendesk